Search results

Where would I find the serial number on a L2550? Insurance is asking and on the bill of sale it's only a five digit number which seems odd. Shouldn't it be longer?

Last winter I bought a 1984 L2550 GST. It was mechanically good, however had significant rust. I spent the summer striping it down to the engine, transmission and axles and re-painting it. I can only upload 5 pictures. If you want to see the whole build here is a link to all the pictures(they...

My L2550 has a battery electrolyte sensor. The battery I have is a closed cell. Other than taking of the dash and removing the bulb is there anyway to get the warning light to turn off. I have attached a screenshot of the manual and a picture of what I think is the sensor wire.

I have a L2550 GST. I just finished tearing it down to fix and repaint it. I had everything of the tractor. There was only motor, transmission and axles left. While apart I also took apart the rear axle to change a seal. Change the hydraulic filter and put in new hydraulic oil. This weekend I...

Were I can I find window latches like these? Actually only need the little round piece on the bottom of the picture but would buy the entire hinge if I can find it. I have searched online and only found some in Europe. Surely these are sold somewhere in North America.

What is the purpose of this part of the tab? Is this to add strength/rigidity? Someone suggested it might be to bolt a wheel weight. As you can see from the picture the tab is rusted. Some even worst than this one. Can I just put a flat plate instead of that Z shaped one? I would use the same...

Anyone have any experience with the Kubota orange paint that Home Hardware sells? Is this good paint? I assume this could be used in a pray gun? https://www.homehardware.ca/en/235ml-kubota-orange-alkyd-implement-rust-paint/p/1823942.

My real axle seal is leaking. If I remove the 4 bolts pictured on the cap will the axle just pull out? Is there anything inside the rear end that hold the axle or that will come apart if I pull out the axle?

How low to the ground should my snowblower be set. I had someone tell 3/4". I find it's leaving a bit to much snow. I understand to close to the ground it will rub and wear out the bottom but 3/4" seems like a lot. I have a paved driveway if it makes a difference.

I recently purchased a L2550 GST. The fenders and floor is pretty rusted. Once snow is done I'm planning to take it all apart to fix it. I can build those pieces myself however would prefer to find used ones in good condition. My question is are there other models that use the same parts? If so...