Search results

So, situation is BX/54 mower runs right up at orange with tall grass. Recent work shows clear radiator (in and out), minimal internal rust, etc. I believe I would NOT trust the water pump next. I got tractor only a few years old. Is it likely the original pump was a cast or formed (SS?)...

Got it! I pulled the head for a tiny, but steady stream of bubbles at radiator cap. I now do not have any bubbles, just a weird standing wave from the vibrations. But no bubbles! I got lucky; machinist found no cracks; my dad's old framing square said it was still flat. Hard to start, I...

When one stands on the left side of the engine, the three injectors run fore and aft. There is a device - 3 donuts joined by tubes, and the tubes continue to the fore and aft - I suppose a return or vent. Mine (and the parts book) is connected only on the aft end, there is nothing for the fore...

Hey - got these 3 combustion areas They seem to be same size and exactly same place, with stake marks? Cracks or not? FRecommend home crack test system? I hope I'm changing head gasket for tiniest of radiator bubbles. Any help?

(These are not flanged.) So, how deep do I set them? They will go, better than 1/8 past flush, to a bit of ridge that seems to be a stop (after bearing hit it's own stop). Thoughts were... seems to be plenty of shaft seal area, go to a new spot? Any thoughts, pros, cons to full depth vs just flush?

Years as above. Bent the unsupported (exit chute) right front on a stump or such. Took wheel (tilted back at bottom) off for a spell, just this week jacked it (the wheel support) up enough to straighten deck back, YAY! Hit another stump today, same bend - it's just out there in the wind, with...