Search results

I was able to measure the link arm at the ball end in the fully raised position and it's right at 33", which matches what DieselD has measured. So, I think it's probably ok. Fully raised my Bush Hog is only 9" off the ground using the lower top link hole. If I move the top link to the upper hole...

These are very helpful, thank you!! So, looks like about 7" total lift (26" to 33") for the link arms (top pieces) from the high setting to low. I'll see if I'm getting the same and report back.

Thanks for the feedback. I actually had to replace one of the arms a couple of years ago when the splines wore out and tried to match it with the orientation of the other. I don't know whether the one I didn't replace was original or not. Regardless, it seemed to me that if the rotational travel...

Thank you.

Thanks for the feedback. Maybe I have it wrong but I believe you're referring to the link arms. The lift harms, or at least as I understand it, are on both sides of the top link and actually do the lifting when the 3PH is engaged.

I have an older B7500 that I bought used. It had been worked pretty hard before I acquired it. Anyway, the 3PH has never raised as high as I would expect. For example, I have a 4' Bush Hog that when adjusted for level at the bottom only raises about 8" off the ground when the lift harms are...

Dan - thanks for the help. I spoke with summit about adding a rear remote and third function and their tech guy suggested I could combine the two with a 2 spool rear remote. 1 spool will be for stuff in the rear (dump wagon is about it) and the other spool is being plumbed to the front to run a...

So, this is good to go?

Dan - I acquired the universal rear remote, 2 spool valve (https://summit-hydraulics.com/product/electric-rear-remote-valve-kit-for-compact-tractors-two-spool-three-spool-four-spool/). I should confirm, I do not have a Land Pride setup; I just stumbled across the instructions for a 3rd function...

I realize this question has likely been answered many times in this forum, but I've been searching for a couple of hours and can't seem to get a clear answer. Anyway, I'm installing a Summit rear remote kit and have a question as to how to plumb it. I thought I was supposed to do the following...

Thank you.

CTFJR - If you don't mind, where did you get the mounting bracket in the top pic? I'm running a 3rd function off my rear remote and want to have a disconnect by the loader valve in the event I want to remove the loader. Thanks for your help!