Functional upgrades to the M6060 including sprayer controls, LEDs, power distribution and more.

[GBJeffOH]

I have a TeeJet sprayer control kit coming next week and have started to think about how I want to mount the control box. I can't find any information on the dimensions so called TeeJet and was told that that the box is 7"x3-1/2"x2-1/2" (WxHxD). I think the B-pillar, for want of a better description, on the right side of the cab is the way to go.

I know that I want to add an additional display at some point for mapping and/or cameras front and rear so something that is expandable is important. I saw a pillar mount on Displaybracket.com (shown below) that looks good so could make something similar that could mount to a plate that's bolted to the B-pillar.

I have a nice rivet nut kit so could drill four holes (see white dots below) and mount a plate with standoffs that I could either weld or bolt brackets to as needed for additional accessories. I'll also be adding a Painless Wiring power distribution kit behind the seat to run various accessories including LEDs.

More to come on this project as it progresses.

View attachment 173276

View attachment 173278

View attachment 173277

 

[GBJeffOH]

I used CLICK BOND KIT D METAL studs. Very strong. No drilling.

Click Bond Kit D Metal KA4A1 | Aircraft Spruce ®

Click Bond Kit D Metal KA4A1 Click Bond Fasteners mount to surfaces with adhesive. They are assembled in a disposable, self-fixturing device of plastic that aligns and holds the fastener in position and under controlled pr...

www.aircraftspruce.com

 

[McMXi]

I used CLICK BOND KIT D METAL studs. Very strong. No drilling.

Click Bond Kit D Metal KA4A1 | Aircraft Spruce ®

Click Bond Kit D Metal KA4A1 Click Bond Fasteners mount to surfaces with adhesive. They are assembled in a disposable, self-fixturing device of plastic that aligns and holds the fastener in position and under controlled pr...

www.aircraftspruce.com

Well, since I have a mag drill and steel rivet nuts I chose to use them. It was an easy job, but if drilling were not an option I might opt for stick on nuts. Glue on nuts are more like David Beckham in a dress rather than Mick Jagger. I don't want to embrace either, but if I had to make a choice it's David all the way.