I would like to thank everyone for their input, I‘ll post a few more images I do have a few questions from the responses starting with, Is JB Weld resistant to solvents ie: gasoline? if not can anyone recommend any kind of epoxy that is resistant to solvent? I do have some bushings that I could use as a sleeve, I used a 3/8 piece of pipe and used JW Weld on one end with a lubricated bolt and the same on the other end with some 608 Clear Epoxy patch. I was going to soak it in some gas to see how well the epoxies hold up, my other question is about the propane/natural gas conversion kit, i’m not familiar with these conversion kits, can anyone recommend a company that sells them, would I still need a carburetor? I’ll attach a couple pic’s of the carb’s bolt & bore openings just incase someone might have a carb that they could recommend. And a couple pics of the intake manifold to see how I could add a Multi fuel set up, And thanks Wolfman I did look at the carbs you recommended but they were to small. Maybe I could Ck. To see if theres A Mikuni carb forum, I would probably have better luck finding the stock carb, Thanks for all the suggestions
View attachment 97889
View attachment 97890
View attachment 97891
View attachment 97887
View attachment 97888
