Recent content by ZipFunk

Backing to the box is not bad. Its really just getting the vertical alignment for where I put the lower two pins in. The top 'arm' of the hitch is fine. I just find myself trying to get the right height and depth to align the pins. When I get one inevitably the other isnt aligned and I have to...

I figured. Thank you. I'll try that.

It does. Can you post a photo of the dolly so I know what to look for?

If this is the wrong forum I apologize. I often find myself putting on/taking off the ballast box of my 2380. when I take it off it sits on a platform of 4X4s. No problem. Putting it back on is always a pain. Lining up the three point hitch is okay. But getting the right height for the lower...

Thanks for this. I haven’t bought them yet so I’ll try to pull them out carefully and see if I have the same luck.

Thank you for that. I'll order them now

Good plan. I’ll do that. Thank you.

I need to replace a valve stem on my BX2380. I believe its a TR13 but when I shop for it TR416 metal stems pop up a lot. They seem to both say they're the same size ("Fits 453" and .625" Valve Holes") Is it 6 of one half dozen of the other or should I buy one over the other?

This isnt a high priority question by any means but I'd like to take the rubber 'floor mat' off my BX 2380 sometime and clean under it. I assume the rivet pins will break when I try to take the mat off and I'm wondering what pin size I can buy. I've googled it and I get no real size, just...

Thank you for this. I'll measure and buy the right one.

I had the valve stem blow out of the rim yesterday. I was moving brush and scrub and a piece of wood must have pushed against it and ripped it out. Is it just a standard valve stem or is there a numerical code etc to get a replacement?

It sounds like it probably doesn't matter?

Hi Guys I’ve always had a little makeshift stand made out of old 4X4s to sit my ballast box on when I park my BX2380. The ballast is probably about 400lbs or so. I always just figured taking the weight off the hydraulics, etc was a good idea when not in use. Is this something that’s necessary in...

I didn't even think of rubber mats. Any thoughts on what brands are good for rear chains? (Just got the reply from JoeR while posting this. Sorry for the double question.

Hi Joe, Thanks for this. I only have a gravel driveway so no blacktop to wreck here. Two questions... I do park the tractor in the garage which has a cement floor. Would it be wise to throw down some cheap used plywood to park it on? Do you have a brand of chains or are there Kubota chains...