Recent content by zcases

Sorry I wasn't clear. The boss/ID splines are stripped, the pulley is OK. The OD splines are good on the HST shaft, so I am now trying to figure out what other kubota models use the same spline dimensions and I will cut out the splines and bore the boss to put the new splines in. Crazy...

Also not available, thanks Dave!

Well - update: The 76650-22110 Pulley Boss (splined boss that mounts the pulley to the HST input shaft) was stripped! Now it appears to be a discontinued part. So before I start manufacturing a new one - a) does anyone need one or better yet b) any ideas on where to go for a used replacement...

Just washing machine in order to do some repairs on the deck like belts and some bearings. Couldn't resist trying to get the engine and hydraulics clean as well. Not 100% sure that is related, but after the wash and heading back to the shop, I move about 10-15 feet on a small incline I lose...