Recent content by wlollar

It appears that the 2 switches are side by side and screw in to the tractor housing. Each has two male pin terminals. I priced these switches today at local dealer, one is $30 and the other $60. Is there a way to check which I need or should I replace both. I'm curious as to why you and Idaho...

Thanks for bringing that to my attn. Can you tell me approx. location of that PTO switch? Oh...it's L3200, standard 2-wheel drive, gear drive. BTW Wolfman, you helped me with fuel filter O-ring. Thanks for that! I made my last payment on my tractor this month, and this is the 1st part to have...

I have a L3200 Kubota. Is the kill switch under the seat the only switch that might go bad(malfunction)? Just recently, the engine has started to cut off when I dismount, even with the parking brake set and shifter in neutral as it should be. I just need to know If replacing that switch will...

Well there was no small O-ring on the outside of that tube. I'm going to take the bowl back off and re-inspect everything. Hopefully this will be my last question. Do the O-rings, big one and the little one, just lay where they fall into place naturally or are they supposed to be stretched and...

Would it be INSIDE the small tube that drops down from the top of the housing? I inspected that tube and there was no small O-ring on the outside of it or stuck to the end of it. I didn't look to see if maybe it was up inside of it.

I have an L3200. I recently did oil and filters change and when I removed the fuel filter, there was only one O-ring...the large one(#6A320-59940). I see in the owners manual there are two O-rings shown for filter #6A320-59930. Where exactly do you place the small O-ring?