Recent content by Wisco608

  1. W

    B-2400 slips out of 4wd while turning

    Thank you so much for the guidance! The people here are great! I will do that first!
  2. W

    B-2400 slips out of 4wd while turning

    Next week I’ll pull it into the shop. Plan on dropping and straining the axle oil. I’m thinking that should get me in a direction if it’s at the hubs or in the differential. I will post up what I find or perhaps be still lost.
  3. W

    B-2400 slips out of 4wd while turning

    That’s very hard to determine as it has a full cab
  4. W

    B-2400 slips out of 4wd while turning

    Yes it does have bi-speed
  5. W

    B-2400 slips out of 4wd while turning

    I have a B2400 4wd that when I turn the front wheels (steering) the 4wd stops working or feels like it slips out. It then goes back into 4wd when the wheels are straightened. It does make a clunk or grinding noise when it goes back in.
  6. W

    B-2400 Overheat issue

    Ok so today is May 4, 2022 and thought I had the overheat issue fixed. Ran all winter plowing snow with no issues. Now it’s spring well kinda here in Wisconsin but warm enough to be the grass growing. I picked up a 60 inch mid mowed the lawn takes about 1 hour and at the end of the run it...
  7. W

    Rear PTO Not Working B2400

    I have a B2400 4wd, Bi-speed Turn and HST. The mid PTO shaft works. The rear PTO shaft does not engage. The cab engagement lever has ZERO resistance when sliding it from off to on and on to off. Assumption is the lever inside the housing is broken, as I followed the lever to the housing and...
  8. W

    WTB RKC60-24B Mower Deck

    Looking for a RKC60 Mower Deck for a B2400. I will also need the tractor side hardware/lift kit. Located in SouthCentral Wisconsin.
  9. W

    B-2400 Overheat issue

    Thank you for the wheew I do not have bubbles like that
  10. W

    B-2400 Overheat issue

    Update: Last evening I followed the steps you recommended. The Temperature at the thermostat housing was 198F That was after running at high RPM’s running the loader to mix up a dirt pile and driving it short distances, to get it up to temp. I did observe a small dribble of coolant running from...
  11. W

    B-2400 Overheat issue

    >JerryMT I will check as you described. Thank you for taking the time to write this up for me. I will report my findings.
  12. W

    B-2400 Overheat issue

    I have a B-2400 that has an overheating issue. Do not know age other than 350 hrs. Has cab with Aux heating unit and FEL. At mid rpm range it will leak out the overflow not a steady flow. The temp gauge will be about 1/2 way up. Usuall At Near WOT it will overheat after about 15 min of run...
  13. W

    Mower deck

    I know this an older post but figured I’d check and see if you still have the RC60 mower deck?
See more
Top Bottom