Recent content by Whitetail Hunter

I am looking for the part numbers for a shim kit for a relief valve on an M4050. I see a bunch for the L series, but none for the M series. I have also sent questions in to see if they are the same kit, but I can’t get anyone to confirm or deny.

Yes the PTO works good. I went ahead and adjusted it to the proper amount of free play for the clutch pedal and that fixed it.

I have an M4050 (not DT) that I need assistance adjusting the clutch on. It started grinding and won't go in gear. I have adjusted it with absolutely no play, and it still will not go into gear. I saw some posts on PTO clutch adjustment, but not for the drive train clutch. The guy I bought it...

I have an M4050 that works fine until I am digging a post hole. When the auger goes all the way down, I lose all hydraulics. Nothing works, the 3 point arms or the front end loader. I pulled the pump and had it checked. It is fine. I replaced the filter, cleaned the screen, and changed the...

I've checked the draft control, but not the feedback linkage adjustment; I will look it up and try that; thanks for the insight

I am having a problem with my 3 point lift. When I am digging a post hole, and the 3 point is lowered all the way down, I lose hydraulics to the entire tractor even the front end loader won't work). I thought maybe I was low on fluid (I checked it and it's ok) I thought maybe the pump was bad so...