Recent content by wendol

I like your method of loosen the lug nuts, drive, etc. Also reminds me I need to touch up the rim.......great advice.......thanks!!

I called out a mobil service to repair a flat on the front wheel/tire, and was shocked when he took out his sledge hammer and began to beat (with major force) on the inside of the wheel/tire to remove it. This process took about four attempts. I could only wonder what damage could occur to the...

My old Campbell Hausfeld is on it's last leg, and searching online leaves me with more questions than answers. My primary uses are keeping the proper air pressure in the tractor tires and other vehicles, impact driver, etc. I prefer a 110V unit. Your thoughts, recommendations, and suggestions...

I have had good luck using this one from Harbor Freight........ https://www.harborfreight.com/multi-use-transfer-pump-63144.html

Another take on trash bin carriers........my objective was to have something simple (easy hook up), and that was always available to get the trash bin to the pick up point. This set up serves a couple of needs: 1) basket for the wife's landscape projects, plus the basket is also used for a...

Not a RTV, but same dilemma on a Scag Zero Turn. I didn't realize it had a set of charcoal canisters until after the purchase, and then to learn the down side of having them.........i.e. being careful to not over fill the tank, using a hoist to raise the mower to clean the deck, mowing slopes...

PM sent

As stated earlier probably a Yazaki brand. Here is a link to their Complete Catalog.......with an excellent catalog search feature. https://apps.us.yazaki.com/ComponentCatalog/

Quick question on the Cat 1, Euro hooks. I have all my equipment set up with 7/8" lower link pins (each runs between U bracket). If I converted my set up to the Cat 1 Euro hooks, is this all I need? I don't want to get into any type of additional plates, flanges, etc. Thanks a million for...

Jay, sounds like the finishing touch to get that top removed.......thanks!!

Russell.....sounds like a plan.......I'll give it a try.

Thanks.........great recommendation

Yes gear oil.........not grease......sorry for the mispost!!

I need to change the grease in the gear box..........It seems most recommend method is siphoning out the grease thru either the fill opening or the level fill opening. Some even recommend tilting the cutter on it's side.........not doable for me!! My preference would be to have more access for...