Recent content by Wayne G

I have a MX5400 hstc that occasionally will not start (no fire to the starter), but not because of PTO switch being engaged. I try wiggling range selector, hstc pedal, ect., basically anything that might connect to a safety switch but I have yet to determine what I move that allows it to turn...

Well, I ordered part #HHT1A-91103 and as you would imagine it was the wrong part! I'll go back and order HHT1K-91103. Glad to know you have the right part.

Thanks, Motate. That part should only cost about $15-$20 but they've got us by the ---- so I guess I'll order one ,too.

So part #HHT1K-91103 So the part you ordered is the entire wiring harness or just the pigtail connector that plugs into the PTO solenoid?

Dustball, you saved the day! I have the same problem and have been trying to figure out ways to fix this. Kubota should stock this retainer with about a 6 in. pigtail. The weakest part of this setup is hte wiring where it's crimped to the terminal.

Just trying to compare with pictures.

Which one did you order?

I just had the same problem with my MX5400. It's a Deutsch pin and socket terminal and all I need is the socket (female) side. Such an easy fix that you would think Kubota would have old wiring harnesses that they could strip terminals from. Did you ever find a replacement?