Thanks for the thoughts on the problem. Since there are 2 cylinders controlling the bucket, would a bad seal on one cylinder cause the problem?
Walt Weems
When I place the edge of the loader bucket , model TL720, down on the ground and back up to level the turf, the bucket just rolls over rather then remaining in place.
Am I missing some setting or adjustment?
Walt Weems
The glow plug light on the dash doesn't always go out. No buzzing sound and stays on when tractor is running. Tractor always starts up easily. Would appreciate any guidance.
walt weems
The glow plug on my L35 does not go out even though the tractor starts as usual and I do not hear the buzzing sound that I heard in the past. The light stays on when the tractor is running. I'm looking for some advise on where to start looking for the problem.
Thanks
Walt
Thanks Wolfman I got it off and I'm taking it to the dealer for a rebuild. When I reinstall are there any alignment issues I should be aware of?
Thanks,
Walt
I'm removing the cylinder because of a leak and need to know how to remove
the pin in the rod end stopper below the radiator. There is a odd looking cap on top of he pin and I'm not sure if this cap is removed.
Thanks,
Walt
L2900 glow plug light was not working. I replaced controller and relay. Now the light comes on but only stays on for 1 or 2 seconds. What am I missing? Is there a timer somewhere?
Walt Weems
Re: Glow Plug issue
I have replaced my glow plug controller and relay on my L2900. Now the dash light comes on every time, but it goes off immediately, only on for a second or two. Is there a timer ?
Walt Weems