Vlach7's latest activity
-
VVlach7 replied to the thread mid 90's L5450 recommendations for sun canopy and good fork lift attachment? strong ones..Got mine from Titan for my quick attach and love the forks 48 inches
-
VI am a little confused, there is no foot pedal accelerator. The foot pedal is the HST control. The only time it increases rpm is if you...
-
VVlach7 replied to the thread l47 in limp mode, no codes..Thanks, you were correct, my auto throttle was off.
-
VVlach7 replied to the thread l47 in limp mode, no codes..I do not recall, turning a auto throttle on or off.
-
VVlach7 replied to the thread l47 in limp mode, no codes..I’ve only had it five years and maybe I did have a senior moment but it’s working now and I will be more aware of that auto throttle...
-
VVlach7 replied to the thread l47 in limp mode, no codes..Not sure, couple weeks ago I had that P0336 code come up about lugging it or engine going to slow RPM and I cleared it the same day I...
-
VVlach7 replied to the thread l47 in limp mode, no codes..Merry Christmas to all, I am blessed, went back out to try the manual or hand throttle and not the foot throttle. Every single thing...
-
VVlach7 replied to the thread l47 in limp mode, no codes..Thank you. This was a sudden onset; I clean my air filter all the time and for the most part only tractor after a rain. after I study...
-
VCheck your air filter
-
VVlach7 replied to the thread l47 in limp mode, no codes..THANK YOU, already printed it up. Thanks, NIW.
-
VWhere would be the best place to purchase the WSM for my tractor? 800hrs, recently cleared a code for when the RPM drops to low, #P0336...
-
VVlach7 replied to the thread Your Battery Maintainer/Charger choice?.Deleted
-
VVlach7 replied to the thread What to do with ‘yard’ waste?.Get a burn permit, a gallon of diesel fuel, not gasoline, propane torch, wait for waste to be dry dead, wait for moist weather and have...
-
VIf your "problem" was the zerk was too long and bottomed out ... Just file the end off a tad ... Only needs a pump or two ...
-
VVlach7 replied to the thread Greasing front axle pivot pin problem.HG1 think I figured out mine at least, so simple seems stupid, I backed out my zerk 1 turn, It then was able to accept grease so I put...
