Recent content by Ukfan

II know this is an older thread but the diagrams for the 3rd function are at the very end of the LA1154Assemblyinstructions.pdf manual.

https://www.amazon.com/gp/product/B07D2C1FXT/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 This is the switch I went with after considering the HD toggle. It is a spdt switch with a green light. I soldered it in place to keep it from hanging down to low. If I had a plastic cover...

It definitely doesn't leave much room for error. It would be interesting to find out if others are having any failures with their leds. The bulbs made for the 5f series only come in 5, 12, and 24 and I would assume that Kubota is using the 12 volt version. The heavy duty toggle I purchased...

If you go with a 6f super bright, the led will only work if you use a 430 ohm 1/2watt resistor to lower the voltage. The 5f bright comes with the voltage opeational limit for the led built in. At least that is my understanding.

This is what I bought, I purchased an oem style too in case the others didn't fit. I purchased a wiring harness but probably will use spade connectors. There are not a lot of options for a 16mm hole unless you go with a nonilluminated switch.. I'll pick the best one, return the others and...

Yes, my understanding is the solder lugs represented by 01 in the part number are the factory Kubota style. I was thinking the same thing about the slide terminals instead of AT716. It would probably hang down to far. It is a latch on switch and is located on a bracket above the boot of the...

I used a diagram from AT716 quick connect terminal. It is about 17mm tall and I would have to solder it in but if the switch went bad again I could just pull it out of the quick terminal. It may stick down to far and get broken off though. Here is what I think it is and will edit later if I'm...

Thanks Jim for verifying. I believe the part number that I need is YB16WCKW01-5F12-JB. This is the bright not super bright led with 12v resistor built in. Is there another switch you recommend? I have been considering that too, the hole is 16mm round.

Hi all, new to the forum. Can anyone verify that NKK Switches YB16WCKW01-6F-JB led works? My third function M7991 came shipped to me broken without a bulb and the switch had broken internals. It is going on an M7060. Also, is the input voltage 12v? I am assuming it is. Thanks in advance