Recent content by Tractor J

I was at the land last week and sprayed some PB on the shafting area. After trying a few times it moved into 4-wheel drive, bad part I got my fingers between the lever and the casing and cut it up good. They should have made the lever taller. All Good. Thank you for the help it worked great.

Thank You. I will try it next time I'm at the tractor.🙂

I have a B7200D 4WD tractor. About 3 months ago I shifted it out of 4WD ( no problems doing it) and now when I try to put it in 4WD it will not go. The level will not move at all. There is no noise or sound. What can I do to get it to shaft to 4WD. Thanks

Touching the leads together I have 0.1 and when I touch the Dynamo wire I get 0.3, so I have a 0.2 reading Thanks for the input.

Would a 0.3 ohm be good? Thank You for the info. John

I have a B7200d and replaced the dynamo (P/N- 15531-64013). All is working great. I disassembled the old Dynamo – P/N- 15531-64013. The housing had caked on dirt on the housing, The copper wiring looks good. Bearings all feel good. How can I test the winding to see if the winding is good. With...

Thank you, I will check it

I have a B7200D Kubota, I had a low battery and I check the battery with the tractor running and it was 11.78V. How can I tell if the Dynamo is bad? How can I check the voltage regulator is bad? Thank For the Help

Thanks. That is what I did.

Thanks. That is what I did.

I'm looking for a Top Link that will working on my Kubota B7200D. I know it is a Cat.1 Hole Die. 3/4", Body length 16", 20" min. to 29" max. But the Ball width can not be over 1-1/2. Thanks

Thank You. I sent a email to them for the manual.

Thank You good Video

Thank You