Recent content by TomRC

Additional Pictsi

NOTE: THIS POST INCLUDES ALL THAT I"M SELLING I'm dealing with some health issues and its getting hard for me to even hook pto driven implements up to the tractor so I'm thinking about selling everything I've got which includes the following. All purchased new by me and all Garage kept except...

Bump!

Still available. PM me if you need more info.

Pulling the disc with my Scag???? That would be a sight to see. Think I'll reserve that task for the tractor!

Yep, PTO shaft is included just not in the picture. PM me if you need more info. Thanks! MOD EDIT: No email posts on open forum. ;)

I was convinced a 25hp would be adequate for a property I recently sold. Had to maintain about what it sounds like you will have and yes the 25hp got the job done but I would NEVER go with a 25hp again strictly due to mowing. You want to be able to pull atleast a 60" mower with EASE in MEDIUM...

EVERYTHING IS SOLD NOTE: I just modified this listing to include my Kubota B2601 tractor and some additional Landpride implements, see post #10 below for all that I'm selling. Landpride RTA1250 Tiller (50”) - Bought new fall of 2020. This tiller is PRACTICALLY new. I used it right when it was...

If I could make one improvement I'd make them a little lower to the ground. Ended up changing to a little longer toplink to make for easier on and off. Otherwise very easy to move around! Made one bigger that holds both the box blade and the tiller.

I need to replace the belt on my Landpride FDR1660 finish mower. Landpride belts are around $100. Any good aftermarket kevlar belts that cost less or just bite the bullet. Also, I'd like to get a belt tension gauge so I don't have to rely on the "press with your finger" method if ya'll have any...

Just an unpleasant task with no easy solution. Unless I pressure wash after every mowing session the pressure washer just doesn't do a good job once the grass hardens at all and I have a very good pressure washer. Takes me about 4 hours to mow my place and pretty much a weekly task so by the...

o Is it tricky relaxing pressure on the come along without the mower crashing down?

LP rates nothing larger than a 4 footer for the B2601. I can ASSURE YOU on the B2601 I've had several instances where I almost needed to change my drawers with the 5 foot FDR1660 when I've had to lift on anything other than level ground on my B2601 and I am careful. Plus if you have any slopes...

Thanks and that attachment might make it lot easier and not much effort to wash after every use without having to unhook it and lift it up. Is there any potential area underneath a finish mower where you could cause damage or issues with high pressure water?

NO WAY would I pull a 6' mower behind the B2601. I pull a 5' LP finish mower behind my B2601 and I have to be VERY VERY careful when I lift in on anything other than level ground even with the loader and bucket attached to offset the weight. I'm sure it could turn a 6 footer but that's not the...