Recent content by tkblevins

Removed hydraulic pump, replaced seal and fixed problem. Thanks!!!

Found my problem. I had a piece that was bent and when you pressed the pedal forward or backward it was getting in a bind. To off and straightened. Now works like it should. Thanks!!!

Thanks, I'll try that!!

No it's not catching on anything! It just stays where you put it!

I'm having the same problem. Did you get yours fixed??

B7100HST. The hydraulic shift lever/pedal does not return to neutral when released. If going forward when take foot off the pedal stays where it is. How do you adjust this. Dangerous!! Thanks for any help offered.

Iappreciate all the info! I've ordered a seal and will start from there. Hopefully that will do it. Thanks again!!!

Was your oil very thin. Ours is very thin, black and smells like oil. Our hydraulic oil is clear so hard to tell. I would appreciate the link very much. My email is tkblevins1@gmail.com. Thanks!!!

Appreciate your recommendation very much. Is the location of the pump the same on a B7100? Will probably start with the seal and change the engine oil & filter and see what happens.. Thanks again!!!

I can't tell because it is down some but we have a few leaks with the loader and we have not been using it very much and have not checked it. Thanks!!!

Also forgot to mention. We recently used loader quite a bit spreading mulch and also used ripper to rip gargen. Would this cause increase in leak that we might not have noticed before. We have only had the tractor about 6 months and not used it hardly any. When we got it we changed all...

Have a B7100 HST with 736 hours. Slow leak into engine oil. How can tell if it is fuel or hydraulic oil. Looks like it is about 1 1/2 qts over full. Transmission fluid is down alittle but we have a few small leaks. Oil don't smell any different. If it is fuel will it smell like fuel...