Recent content by tinygiant

Thanks for the help. It ended up being self-critiquing. All of the bolts holding the cowl panel down are shown somewhere in the service manual, except for a single screw on the center of the cowl just above the instrument panel. Finally found it (covered in dirt and hidden). Took it out and...

I'm trying to get to my messed-up brake pedals and parking brake lever. I need to remove the cowl panel and have found four screws holding it in, but there appears to be another attachment point at the top center of the cowl panel. There's no obvious screw/bolt from the engine side. There is...

Thanks for all the info and links. I'll let you know how it turns out. Sent from my SM-G950U1 using Tapatalk

ZTMAN, I think I didn't get my intent across clearly. I'm looking for an implement-side quick hitch frame to build an implement around. I already have the tractor side. Right now, I'm seeing bare a-frames that might be usable, but not much else. Thinking that might be the standard. Sent from...

I've got one of those, they work great. In this case, though, I need it to be quick hitch compatible. I haven't seen a trailer mover that is, probably for good reason. If the is one, though, that might work really well. Sent from my SM-G950U1 using Tapatalk

Thanks, I'll look for this one and check it out. Sent from my SM-G950U1 using Tapatalk

Hello all, I'm going to have a custom mounting system created for one of my 3PH attachments and want it to be quick hitch compatible. I've seen several A-frame type quick hitches on the net for around $200. Anyone have any experience with these as a base for a custom mount and, if so, any...

Good to know, thanks! Sent from my SM-G950U1 using Tapatalk

Thanks for the help! Sent from my SM-G950U1 using Tapatalk

SDT, Thanks for the insight. I imagine it'll normally only require about half load on the gen, with short bursts (major system startups) at much higher loads. I guess some experimenting is in order once I have everything set up. For those with ePTO, can you swap between the two under load, or...

Lugbolt, I'm trying to figure out what hp might better present at epto speeds. The gen I'm using only requires 50 hp to run full power, so it might work for me if 50 is present at the lower rpm, but I don't really have a way to measure it. Sent from my SM-G950U1 using Tapatalk

Wolfman, SDT, Sounds like the 1000 rpm PTO would be great for this application, but so far as I know, they weren't offered on the 7060 (HD8). If I'm wrong, please let me know as I'd love to find a kit to modify the tractor. The only mention of 1000 rpm pto in my manual is a dash light...

SDT, Thanks. I knew about the 1000rpm on some tractors. I was wondering in particular about the adapter he said he used. Haven't heard of that before. Is that some kind of external gearbox to create the 1000rpm? *edit ... after a little searching, I'm making the assumption he has a 1000...

Wingnut, Can you expand on that? Did you run the same generator through some kind of 1000rpm adapter? Can you point me at an example of one? Did the generator output the same power because it was running at half speed on the 1000rpm? Sent from my SM-G950U1 using Tapatalk

Wolfman, actually a really good point. I was wondering the other day if there are any resources that have data about available horsepower at various rpm (PTO and ePTO). Know of any? I understand Kubota doesn't have these tractors tested at UNL, so this body of knowledge may not exist. Sent...