Recent content by thorpboy

Update: I tried to put a 29" belt on (the next smallest size in a 1/4" w belt), but it was too crowded. So, I dealt with the stuck adjustment pulley by removing the radiator and fan, taking off the pulley adjustment housing and repairing the pulley tensioner. Set it to slack, put the belt on and...

Re: Belt adjustment on B700D It's my fan belt. The picture shows how I think the pulley is supposed to move to adjust the belt tension, but the pulley doesn't move. If I can't fix it, I guess I'll try to find a 30" belt (1" shorter) and try to force it on the pulley. Has anyone else had this issue?

I installed a new 1/4" x 31" v-belt on my B7000D, but when I turn the wingnut (bolt) to adjust the tension nothing happens- the pulley remains in the same position. Has anyone out there been through this? Is there a spring inside the pulley housing? Help!

Does anyone know where I can get a replacement belt for my B7000D or provide a NAPA number? The belt is in bad shape and the weather's just getting good. TIA

After awhile the pto shaft just stops turning when the tines hit the dirt. If I let it sit for a few hours, it works fine again. I'm suspecting a heat issue, but maybe it's my pto pump?

The gray market tiller behind my B7000D works great for about 15-20 minutes, but then won't turn with even the slightest amount of resistance. Anybody know what's up with my pto to cause that? The tiller is fine, but the pto won't rotate when the tines hit the ground after a while.

I'm looking for the PTO linkage to connect a B7000DT to a gray market tiller using the two point connection (the tiller connected directly to the two posts on the frame).

I have a B7000D with the same type of tiller. I mounted it using the 2 point mounts on the frame. What I need, however, is the small yoke linkage that came with yours since there's only 6 inches between the pto drive line and the spindle on my tiller (see photos). Are you interested in selling...

Here's an view from farther back...

My grey market 7000D came with a Kubota tiller. When I got it hitched up I saw that I only had 6" between the PTO shafts (see photo). Is there a connector/clutch that small? How in the heck do you hook this system up? TIA

I wasn't sure if I should post here or the implements section, so I'll start here. The B7000D I'm buying comes with the tiller in the photos. The only numbers I found stamped on the tiller were 5203M. What I need to know is: 1) There are two oil caps on it- on the top and one on the side (main...

Thanks for the photo...I think you're right about it being a B7000D. Here are some other alpha-numerics I found on various locations: Front axle-6122 Front of left wheel hub-6226 Front differential-B1 07 (I think, it's hard to say for sure) Right front wheel hub-A2 5 My next thread will be about...

Yes, this thing was spray-painted orange and the plate's been removed...I can see four holes on the left side of the tranny where it was originally. From the previous poster's photo it looks like his was by the pto. BTW, the pto on this turns clockwise. Everything on this tractor works and it...

It's a two cylinder. I found NW K2-B stamped on the engine block, but I don't know if that's an ID for the engine or the model.

Let's see if a larger photo can be uploaded.