Recent content by thomas57

my kubota will not push in gear or out // up or down ,, with the hydraulic trans . the only way i can move it is to crank it // just to move it 2 feet . is there any way to move it two feet without starting the die. let it warm up then drive it the two foot i need to move it ? ?

I have found the same thing on my die ,, it was a part of a tree leaf that would float over and sometimes clog the fuel hole // was a pain to find , why some times run then stop or run bad the leaf will float around when the pump stopped .. hope this will help

I have found the same thing on my die ,, it was a part of a tree leaf that would float over and sometimes clog the fuel hole // was a pain to find , why some times run then stop or run bad the leaf will float around when the pump stopped .. hope this will help

how to adj the idle on my kubota 2110 die. ( D 782 engine ) after idle the thing runs very good // there is a little PING \ raddle noise some were in the motor ? I did replace the INJECTORS and glow plugs because it had 1200 + hours on it .

yes it did run but ruff so I shut it off ,, both before and after oil change ,, got 3 new inj but did not put in yet

I got a used kubota mower with kuboda eng d782 compression is low 270 lb on all 3 cyl . after I put a little oil in each cyl it will go to 400 psi . are the rings bad or just stuck ? it only has about 1037 hours on the mower ,, but was sitting for a wile ( do not know long ) the oil that...