TheOldHokie's latest activity
-
TheOldHokie replied to the thread FEL slowly goes down..By all means readf all you want but most descriptions are pretty technical and about as clear as mud. Here it is in a nutshell This is... -
-
By 'lever' do you mean the 3ph control lever? If so, you probably need to adjust the feedback linkage so the 3pt doesn't go into relief...
-
TheOldHokie replied to the thread FEL slowly goes down..Large or small, load check valves are standard in almost every loader valve made in the last 50 years. They dont prevent cylinder...
-
-
TheOldHokie replied to the thread 1630 loader hydraulic controller replacement.I assume so. The IN/OUT ports are SAE 10 and the PB is SAE 8. Look at your hises tk see what you have there. Dan
-
TheOldHokie replied to the thread FEL slowly goes down..My guess is bad/dirty load check valve. Dan
-
TheOldHokie replied to the thread L4540 backhoe hydraulics rebuild.The seals in rhe valves dont do much. When they fail you get external leaks. Sticky is commonly the joysticj linkage or dirt and...
-
TheOldHokie replied to the thread Teach me about hydraulic motors.Assuming you have sufficient flow that would be my choice. Heat is the main enemy. A dedicated valve with motor spool and direct tank...
-
TheOldHokie replied to the thread 1630 loader hydraulic controller replacement.The OEM valve is a bit smaller and IIRC has SAE-06 vs SAE-08 ports so not 100% plug and play. The port layout is the same so a little...
-
TheOldHokie replied to the thread Teach me about hydraulic motors.Yes, he needs a relief for any size pump. Dan
-
TheOldHokie replied to the thread Teach me about hydraulic motors.Flow determines motor speed Pressure determines motor torque. In his application pressure will never go higher than needed to spin the...
-
TheOldHokie replied to the thread Teach me about hydraulic motors.For fixed didplacement pumps like that PTO pump flow is proportional to RPM. I would suggest you add a control valve with a motor spool...
-
Don't limit yourself to diesel shops, there are many small engine, marine, motorcycle and import auto shops that should be able to help you.
-
TheOldHokie replied to the thread L3010 with LA482 loader, would like to put a 3rd function valve on, does anyone make just a simple mechanical valve?.Pretty much trivial. Just hang a valve next to the loader valve. Dan
-
-
TheOldHokie replied to the thread Adding a single rear remote.No. No, No!!! Stop experimenting and start asking questions. You will get good solid advice and its not hard to do. Start by posting a...
-
TheOldHokie replied to the thread Getting more lifting power for a LA211 loader.What you are describing is increasing the hydraulic system pressure on your tractor. The shims are readily available - proceed at your...
