TheOldHokie's latest activity
-
TheOldHokie replied to the thread Kubota Standard Bolt Grades.You are way overthinking an ordinary everyday activity. Dan -
TheOldHokie replied to the thread where to buy cylinder repair kits.340 hours is nothing. The leak is a rod seal. Replace the leaking seal and leave the rest alone. Dan
-
TheOldHokie replied to the thread where to buy cylinder repair kits.You need to rebuild all 3 cylinders? Dan
-
TheOldHokie replied to the thread B7200D gear lever leaking hydro fluid.Its just a boot Dan
-
TheOldHokie reacted to PoTreeBoy's post in the thread Lift arms on 2350DT stuttering with auger attachment with
Like.
Does that L have draft control? I had a similar problem with my neighbor's JD until I figured out I was using the draft control o_O... -
TheOldHokie replied to the thread Steering Upgrade.Its a proven design that has been used for decades by just about every OEM. Dan
-
TheOldHokie replied to the thread Kubota Standard Bolt Grades.That of course is the tried and proven German engineered GootenTite specification. Dan
-
TheOldHokie replied to the thread Kubota Standard Bolt Grades.The G2160 WSM had a great crossreference tablr. IIRC Kubota 7 = ISO 8.8 Kubota 9 = ISO 10.9
-
TheOldHokie reacted to McMXi's post in the thread Lift arms on 2350DT stuttering with auger attachment with Like.
Did you try the hole nearest to the rear of the tractor as well? Your lower lift arms appear to move up and down as smooth as can be...
-
TheOldHokie replied to the thread Lift arms on 2350DT stuttering with auger attachment.Boy you like to make things harder than needed. Unpin the boom om the PHD. run a 18" long piece of rope through the pinhole and tie...
-
TheOldHokie replied to the thread Lift arms on 2350DT stuttering with auger attachment.I woulð have alreafy tried all three 👿
-
TheOldHokie replied to the thread Lift arms on 2350DT stuttering with auger attachment.Thats exactly what I mean. Does this shudder make the implement unusable or is it just a nusiance? Dan
-
TheOldHokie replied to the thread Lift arms on 2350DT stuttering with auger attachment.Ir works fine with other three point implements so its seemingly specific to the PHD geometry. See what happens if you disconnect the...
-
TheOldHokie replied to the thread Lift arms on 2350DT stuttering with auger attachment.I missed that revision to rhe story. In that case I would suspect binding in the lift geometry. Dan
-
TheOldHokie replied to the thread L4701 with 3rd Function.I knpw zip about that mower but a quick search indicates 9-22 GPM flow. I think thats not going to be a good match for your tractor with...