Recent content by Swanny

While synthetics have greatly improved the cold start situation, they are far from being the holy grail of wear reduction. Case in point-industrial emergency gensets which are still largely installed with lube sump heaters to “Maintain the oil in the sump in a warm condition to provide for a...

Chiming in on an older thread..... Putting on my engineering cap, the two types of heaters serve two different purposes. The coolant/block heaters primary function is to aid in starting & provide a quicker warm up. The oil pan heater is more to prevent excessive wear on the engine resulting...

Don't suppose you still have this hoe & frame still available??

I have an RC60-21B that I have no use for. But I can't imagine it would be cost effective to ship it to the UK. :-)

Assuming the hoe runs off the tractor hydraulics, not a separate PTO pump, then the hoe hydraulics likely connect in series between the loader valve(power beyond) and the 3 point. The factory setup on the B2150, with a factory loader, is the 3 point gets its pressure from the power beyond port...

Question for the obvious experts in this thread, on a related topic: The 3rd function valve I purchased does not have a PB port on it. Its P port connects to the PB port on my loader valve, and then the tank port connects back to the PB port on the tractor, which of course feeds the 3 point...

Realize this thread is a few years dated, but did you finally fix the problem? If so, what was the solution? I have the exact same problem on a B2400 with an LA351 loader. Loader lever works perfect in all positions except pulled all the way down, then the upward motion of the loader stops...