Recent content by stevenrb718

Haha not a problem. So the turn signals are the only things that aren't fed through the CPU. I was afraid that CPU might've been dead. I think I did a quick search before for a replacement IC without success, but I'll have to look again. Hopefully it's not a programmable chip.

I mentioned previously it's a BX1870. I know they recycle the gauges for various models also.

I'll get some pictures next week. I've rebuilt the damaged traces that I can find, and reflowed the ICs. Nothing functions except for the turn signal LEDs. I'm getting various voltages at the wiring harness, but without a schematic, I don't know what voltages should be where. I've checked...

Anybody happen to have the schematic for a BX1870 instrument cluster?

I have a BX1870. The entire cluster went out awhile back, except for the turn signal indicators. I've opened it up and found a fair amount of surface corrosion, but nothing crazy. I repaired a few traces and a couple vias with no change. I know they're terrible with their water sealing and I...

Does anybody happen to have a replacement instrument cluster for the Kubota BX? I've had no success repairing mine without a schematic and I'm not looking to pay $400 for a new one.

Does anybody have a schematic for the BX dash gauge cluster? My cluster has been intermittent and has recently gone out completely. I've found some corrosion and had to rebuild some traces and a pin, but it's not doing anything. The only life i get out of it is the turn signal blinking LEDs...