Recent content by Steve H

Thanks for the advice.

Hi Guys, My B1600 slips out of low gear when I start move foward. I can keep it in gear if I hold the lever. I am thinking there is a part that is worn out but I do not have a manual so Its hard to idenify the part. Thanks in advance. Steve H

BACK IN BUSINESS.... changed the fuel filter and bleed the line and she started right up. Thank you all for your in put.

Mine is 36 x 28 with 10 ft. walls and a 5" pitch gable roof with a carport on 1 side. there is plenty of room to work on the inside. but after it was built I wished we went bigger.

Cleaned and tightened the battery treminals and now I have power. She starts up now and runs for a minute then cuts off again. I will bleed the line again and change the fuel filter and hope that takes care of the problem. Thank you all for the help.

Thanks Bulldog. I will give it a try and let you know the outcome.

Hi all, Its been a while since I needed help with my B1600. Its been running great for years until I accidently ran it out of fuel. I started bleeding the fuel line as per the video and my 4 year old battery died. so with the new battery installed I continued to bleed the fuel lines. she would...

I am not an expert but I have cut some brush. Mostly high grass not too thick. I have run between 1800 and 2000 RPM's. It seems to cut good.

Thanks Todd. That thought did cross my mind. I will take both sides off and have them reinforced.

Hi All, The front loader on my B1600 has no idenifing marks. the other problem is one of the support brackets has started to crack. I bolted on a piece of 3/8" steel as a temp fix. Does anyone know what model loader this is and where I might find a replacement part. Thanks for the help in...

Thanks Vic, I'll post some pictures tomarrow. Your vidios have been a great help already.

Hi all. I am new to the site. I have a B1600, D950 engine w/ front loader. I have a few questions. What is the best way to clean the engine and what should I be careful of? The engine seems noisy, even for a diesel, Is 30 weight oil too thin? south eastern Virginia. How can I tell what type of...