Recent content by steamroller69633

This is what I thought i could do.

I guess the reason why i am struggling to understand you is i dont have a complete understanding of kubotas power beyond setup. The oil goes from the pump , to the fel valve. Then it is sent on through to the power beyond circuit, unless you actuate the fel valve? Then it goes through the...

Bobcat is 2250psi Are you talking about turning up the pressure on the kubota? Is that by putting shims in the block where the fel lines connect

Thank you. It would be so infrequently used and only by me, that i think it wouldnt be an issue. I just happened to look at my friends kubota and see the plumbing for the backhoe. It surprised me. Only 2 lines.

Its funny. I was going to message you directly before posting my thread. You seem quite knowledgeable in this arena. My question is this, when installing the backhoe, the Pb hose goes to the backhoe, then back to the block. There are quick connects that attach to the backhoe implement and when...

So that is the question. I bought the bobcat and 32” spade combo to move 30-10’tall Leyland Cypress trees. It was a good deal but need work. Engine work and hoses. I fixed everything and last week tried to move a tree. The bobcat wont lift it. Its capacity was 1100 but it is from 1987 so who...

Not sure about the flow requirements but its on a super old bobcat that at its best only made 10gpm. Its not duty cycle, it only pushes blades into soil. Then retracts them when setting the root ball. I imagine it will be slow but the pressures are the same on both machines

Oh and i wanted to say. I was never going to tee the power beyond. I was going to tee the pump line and the tank line. Run the pressure through the spade manifold and back to the tank.

So the spade is for a bobcat. And is fed from the aux lines. It has its own set of 6 spool valves. I kind of figured it out that i need to plumb this like a backhoe attachment. Im going to remove the power beyond line from the fel. Add a 6” line with a quick connect. Then put the opposing quick...

I just bought an L2501 and i already own a tree spade. i would like to plumb auxiliary hydraulic lines to use the spade. my question is , do i split the power beyond line coming from the loader bucket into 2 lines with quick connects that i leave connected when not using the spade, then split...