Recent content by Springer

Yeah, I'm learning that. The Box grader is close. The lower pins have a small tapered sholder that is causing the lower "hooks" not to close. I think I can grind about a 1/4 in taper to match it. The Harrow is going to take a bit more creativity on the upper rod to top link. I think I will...

I just got my Speech cat 1 quick hitch for my BX -2680. I just discovered that my implements are NOT quick hitch compatible. The lower hooks mount okay. It's the upper hook that is a problem. I have a Dirt Dog 48" Box grader and a harrow. I'm looking for advice. I'll post pictures when I...

I got it. It was the seat sensor. I took the connector apart, cleaned it with tuner cleaner, blew it dry assembled it, put the seat down, hopped on and it started right up. Thanks all

I just finished flushing the fuel tank after a nightmare of fuel contamination. Replaced the first filter. Ran great the next couple of days. Have the grapple on the FEL and it is working great with the 3rd function. I let it parked in the field and it did rain all night. I wanted to give...

Here is my discovery. I pulled the filters off along with pump. I replaced the filters and the pump. Ran good for awhile then repeated the problem. I pulled the filters off, assuming they had clogged. But they looked fine. I ran the fuel pump from my battery charger with the suction hose in...

Can you point me in the right direction. Where to purchase a guage and where to tap in?

BX-2680 2021 70 hours My Kubota hydraulics is getting wimpy. I can barely lift the front wheels off the ground when I curl. I used to be able to lift them up and slide the mower under the wheels. I recently changed out the fuel pump and filters. In the early Spring I had a service tech...

Have same and always had troubles with raising and lowering the mower deck. In fact, if I knew then when I bought the tractor (new), I would have not bought the mower deck and went with a finish mower. I hate mounting and unmounting that thing. Having said that, I just finished a fuel...

The BX has a straight shot 4 inch hole. I do strain thru a filtered funnel though.

I am up and running again. What I had was a gel formed by diesel fuel and whatever - probably moisture and biologics. It formed about a pint of what looked like jellyfish. I managed to dissolve diesel fuel treatment. In the process, I replaced the fuel pump and filters. I suspect that that...

I have a little bx-2680. 70 hrs old Last year it would run and then start surging and sometimes shut off. I changed the filters and the fuel pump with a after market one on Amazon. When the tractor shut off, I noticed the fuel pump was warm to hot. But the problem returned almost immediately...

Make sure you are not using an auto fuel filter. It will not pass diesel at the proper rate. And don't use an auto oil filter in the hydralics either. I wish someone would have told my shade-tree tech that.

I have to ask this question, only because it just happened to me. Did you buy those filters from Kubota? Or and auto parts store! I had a tech come up last fall. I had him service my tractor (bx-2680) and he used auto parts!!! Two auto parts fuel filter and an auto oil filter for the...

Pull the filler plug and check if your fluid is real foamy. I had a "tech" service my BX and put a auto filter in place of the hydralic filter. An auto oil filter expects about 60 psi max. Hydralic pressures in tractors ~1850 psi. After about a week, my filter collapsed and my pressure did all...

I am looking in the manual under 100 hour service for bx2680 on pg. 90. They only refence one fuel filter. They show a filter mounted on the left (operator's) side of the engine, downstream of the fuel pump.