Recent content by Smokey160

So, I don’t know what’s going on but the 04811-00200 is definitely not the right one. so I guess I’m confused at this point. Got what I thought was what you mentioned on the part#04811-00200 bit you said 04910-00200 which is what I originally asked for and they said the number had been changed...

No worries. So I got the 04811-00200 from the dealer to install. My other question before I do something stupid is there a specific tork for the three bolts, or just tighten them stug

I attached a picture that was sent in this thread earlier

Oh, sorry, I just made a post to you. Thank you for sending me the correct part # !!!!

Dan, I just went online and looked up the o ring, and it is saying that the part# was changed and the one I have is correct-per the diagram.

I went back and looked at the package that the dealer gave me on the O ring and you are right they gave me the wrong o ring. When I gave him the right part number told he looked it up and told me the part # had changed (by 1 digit) and gave me part # 04817-00200, instead if I looked correctly it...

I attached a few more pictures at different angles, and pointing to where it kind looked cracked to me. Also, I know this may not matter, but I remember when I gave the Kubota dealer the part number for the O ring he said they had changed the number and gave me this one. It does seem to fit...

Well, of course I did not think about a local hydraulic shop!! Thank you for that advice! I’ll post a full length picture tomorrow sometime. Thank You again!!! I really appreciate your insight!

Unfortunately, I don’t have the knowledge or skill to do that.

Sorry for the delay. Have to many projects going. I attached two pictures. It looks to be cracked where you can see the shiny ring around where the bolt. I probably done it when I tightened it too much. any ideas where I can find one? Been looking online but nothing so far. Everything says it’s...

So it appears that the piece is cracked at the end bolt. Yeah! Can’t wait to see what that’s gonna cost!

I have attached pictures and I m going to try to put back together again and see wha happens

So, I took the Kubota # from the diagram you sent me and went to Kubota dealer. They said that number had been changed by one digit. I purchased three so I could add the other two on the other end. I misspoke on the extra screw hole. It is actually on the gear box where this piece attaches. I...

Hi Russell, do you know if there is possibly a gasket that is supposed to go on this? I changed the o rings and noticed there’s a four screw hole but the piece only has three bolts and the fourth screw hole is covered by the piece. There wasn’t a gasket but I thinking there’s something that...

Thank you, sir! That makes sense. From Hat I could see, it appears that I will have to take the auxiliary block off since when I unbolted it the first time it didn’t come down far enough for Me to see the o ring. Thank you again! I really appreciate your expertise.