Recent content by Smokeless

you have been a big help thank you. Problem is I do not know where the "pressure in port" is on the new valve set. AND where is the power beyond port on the valve set that gets a new hose back over the filter to the hydraulic block I am truely sorry for all these questions,, but we are...

Last pic, thanks

Ok, here it is. I would like to know please where to connect a new hose from the loader power beyond port to the valves. Specifically which valve do I connect the hose from the loader port. Believe its the green marked 90 degree union in the pic.. AND I assume the power beyond hose I...

No pics yet, I looked at your first reply where you identified hoses on the hydraulic block, its beginning to sink in ( i think). Lets see if i can answer the mail for pics, but I bet I have same valves you have. Again, its the connections to the valves I would like to confirm. More tomorrow...

appreciate the help, will do this pm

excellent posts all: My delimma: I cant figure out which ports to run the hoses to on the valves. I have a set up like first post, but where do I run a hose where-to-where. The valve end is what is confusing me. Can anyone help there? Thanks

Well I never seen these on my searches, but you have provided and thanks. Not sure which valve goes where but maybe I oughtta quick pestering folks and study. Thanks again for taking the time

That looks good, very good. Thanks for taking the time to post. I bet its functional. I think there are two hoses from the valves to the hydraulic block on the right side of tractor. Could I push my luck and ask you to identify those valve connections? Sorry to be a pest, but I assure you it...

Anyone have Top and Tilt from Fiteright Hydraulics installed on a 3301 or 3901? I sure would like an as installed picture, Thanks

Great post and thank you. So newer model decks will work, with some fiddling. Is that what you are telling us? My mower has allot of hours, but is still strong. Does have a slight trans leak, but it is so slight I just top it off now and then, Thanks

will do, give me a day or two. Yes, 3700 hours and still running strong.

Finally got'er done. The fuel pump was indeed shot. So I adopted Bruce recommendation on an Edelbrock aftermarket pump. Clipped the plug on connector for the hot lead off old fuel pump, soldered to new pump, fab mounting plate and all working. Far less than $196.00 for replacement OEM pump...

Turnbuckle operates as advertised with tiller off three point, will not turn with tiller (or weight) on. Had same issue when blade was attached, until I lifted weight by placing 2x4 under blade, which relieves weight of three point. Tried same on tiller, no soap anyway wen are operational, am...

understand, all level now after taking tiller off. Just seemed to me one should be able to adjust turnbuckle with equipment on, guess not thanks for the post

Done, adjusted fine, in good shape now and thanks