Recent content by semi42

yup...Never drill or weld anything on the rops. if anything needs to go onto the rops (beacons etc)then clamp it on.

if it is supposed to stop with the key, then it sounds like either the fuse for the stop solenoid has gone or the solenoid itself has failed.

it really depends on the switch system, some are inside the seat base some are connected to the seat suspension system..these ones are easy, just adjust the spring rate . sometimes the switches in the seat base are positioned near the front so when reversing or moving around the seat its better...

i remember getting a wooden block in the supplied toolkit once specifically for this purpose but any bit of wood / material will do you depress the clutch, and place the block between the clutch pedal bar and the underside of the floor so it keeps the clutch pedal in the depressed position

i have a g2160 with an electric steering problem. the control box was renewed last year as the steering would not reset. now with the new control box, the steering can be reset fine but after about 20minutes of use the steering twitches then eventually pulls over to the right.the tractor has to...