Recent content by Sdatrucking

Small yellow lever is stop lever on my 7100 throttle lever won’t kill it

Kill lever below throttle

New pistons rings bearings didn’t touch inj pump throttle operates normal till runaway fresh fuel and all filters just slight smoke as expected till rings get seated

On the money not even 5 hours since rebuild

Newly rebuilt ran great started up yesterday ran about 15 min then motor started revving on its own revving way too high killed it let sit for a while then restarted moved it back to its park spot maybe a minutes drive and it was doing it again I’m guessing inj pump messing up in Arkansas...

Just did a refresh on my 7100 but broke a stud on my rocker assy went to my parts tractor grabbed all 3 they are shorter and use a different type of hold down nut for the cover they have a rubber bushing that snaps in cover where can these rubbers be found Tia

B7100 4wd manual tranny front driveline appears to have a cover with a rubber boot that holds it in place my cover and boot are missing slowly getting tractor rebuilt also shaft that connects to drive shaft is very loose that comes out of front diff is there a bearing or bushing in the cone...

Stay away from slime not effective and rusts rim just my experience with it may have worked for others

is it possible you just trashed a clutch could make a grinding sound if it went

Just a thought but thin oil can also come from hyd fluid have you checked levels on tranny seal on pump can leak into oil

You find a tank yet

Using a drill bit on a brass jet is a no go can leave scratches and enlarge the jet damaging it and compromising performance

I guess next it will be mad squirrel disease maybe gov will start payin a bounty on em happy hunting

Unless coyotes come in during the day not a big worry they roost up in the trees owls like em though hawks never bothered mine I’m assuming cause of their size

Get a few guinneas they’ll clean em up just have to get used to the noise plus they are excellent watch dogs