Recent content by scopeman

Thanks D2CAT, The dealer wants about $30 for the bearings and If I cant this taken apart, They charge $65/Hr est 1/2hr.

Guys, Thanks for your input. My deck model is: RC60-G20 I attached a diagram I found of what I have, I can get a pic of my spindle if needed but this is what I have. After doing some banging on it I discovered that "clip" #220 that OBKubota is talking about. got it out and thought I was home...

Hello All, I'm trying to replace my bearings to my left deck pulley. I had one heck of a time breaking the top nut loose, got the spindle out but not sure which way to remove the shaft from. I tried taping pretty hard on both ends but nothing. Standing upright, does the shaft drop out to the...

Hello all, I have a RC60-20 deck from a G2000 that the deck height adjustments label on top of the deck is somewhat scratched off to where one cant read. does anyone know where I can find the deck height adj. specs? photo of label or manual/booklet for the deck? Thanks Kendall

Thanks Wolfman, I was thinking that too. or maybe extreme heat off the manifolds over time.

Hi All, I have a G2000 that has some oil dripping on manifold, I pulled the valve cover (see pics), and wanted to check the gasket, found a couple breaks in a soft gasket except for about 3" or 4" that was stuck in place and hard. It was located where the red arrows are pointed on the A side...

Thanks for the reply back guys! the ground wire at the frame end (connector) had Intermitting problems!! Replaced cable with some #2 i had and fix the start /lights problem. but temp and fuel gauges still no go.

Hello all, Does anyone know or where I can find out how to test for a bad relay box or V regulator for a G2000? I started out with a problem with the fuel and temp gauges not working but was told they did off and on. I have removed all the connectors and put no-ox in them, the two lights on the...

Hello, first time flushing a G2000, I was successful in draining the radiator from the bottom valve of it, the cock valve on the L side does not have any water coming form it, is this normal? is there anywhere here that I can find the procedures? Thanks in advance, K

Hello all, Moving on with the revamping a G2000 my father passed on to me, it seems that the Fuel and Temp gauges dont function and want to find out where I may find some info here on trouble shooting, I pulled the (top)temp sensor and get 34 ohms from bat neg to sensor pin, and 1meg ohm from...

Thanks guys! I checked the frame ground that looked good, went across the bolt and said terminal and the solenoid clicked a few times and finally in-gauged the starter and she cranked up. I think it had been sitting for about a year and frozed up.:)

Hello, was given a G2000 that does not crank and need to load on a trailer, Can someone tell me if there is any procedures in placing it in a (N) neutral state? out of gear if you will, with the HS technology not sure how this all works yet, but when moved the right rear wheel partially moves...

Thanks Idaho Wolf Man! I did check those connections and have 12.46v at the solenoid (bolt) I crossed it with the other bolt beside it. and no spark, I measured the small white wire that is plugged in to a single terminal near those bolts and got 11v with key switch on and 12 plus volts with...

Hello guys, New to the site, looks like a good place to go for getting and giving answers! Well My father has gave me his Kubota G2000 series lawn tractor, but with a new battery, trying the to start it via key switch, there is nothing, once he indicated the the lights on the panel came on but...