Recent content by sardillim

I had a similar issue this is going to sound a little bizarre but the next time you feel like the tractor is vapor locking loosen the fuel cap if the engine starts to run normally again the vent in the cap may be blocked that was the issue I experienced good luck

i use this works fine for me

tested out my new stump grinder

So after doing two fairly large stumps I would say roughly 24 inches round each here are my thoughts. Overall I am very pleased with the unit if I were in the stump removal business this is not something I would use but for me with several acres and an occasional stump here and there it's...

update So it arrived Wednesday so far so good somewhat impressed with the shipping since I did not pay for a liftgate service I had my forks ready on the tractor delivery was scheduled between 2 and 4 never saw a truck and at about 3:45 a guy is walking down my driveway with the unit on a...

Bought one being delivered tomorrow will update later this week

I appreciate everyone's input! I just noticed they dropped the price by $100, and I just can't resist—I'm going for it! I'll share an update after I've had the chance to use it a few times. Thanks again, everyone!

I was wondering if anybody has bought or used one of these budget friendly stump grinders? The way I'm looking at it is this my local Home Depot Is about $350.00 To rent a machine for the day. That is about 25% of the cost to buy one of these. To me it's worth spending the extra money to...

I have the same machine ( LX3310) The only time i really notice the exhaust is during a Re Gen

I've seen my share of one-sided cold wells from Kubota.

F'n genius !! can't wait until the next service to try it

nada

The easy answer is a power washer but I would use a very very low pressure nozzle

$283.48 for a cylinder seal kit SERIOUSLY !!!! I thought Japan was an ally

Wanted BH77 bucket in any condition