Recent content by Sambo

Thanks bucktail, will give that a try

Haha, well to be honest after receiving wolf mans reply, I pulled it off again just to be sure it doesn't line up with any other holes. He was definitely right and I spent a bit of time getting it back to the original spot! This engine has probably sat outside for ten years, gave it a crank...

Thanks. You are spot on. I was lucky enough to get the holes aligned on fitting it up first go and figured it couldn't be that easy!

Hi All, I am re-assembling a 6 cylinder S2600 engine someone else had dismantled. Looking for the flywheel alignment procedure to make sure the timing marks are in the correct position. Unfortunately I don't have a workshop manual. Anyone have the required info? Cheers