Recent content by Ryeder

That is definitely an option...thanks

Good day. I'm replacing the bucket cutting edge on the Kubota and it looks like it's going to be a pain. Any suggestions on how to make the replacement a bit easier? Or, at least more labor efficient?

Thanks for the reality slap...lol. Stupid is as stupid does according to Forrest. The company is Road Parts out of CA. That in itself should of been a warning. Guess it's time to loosen the purse strings and go see the dealer. Thanks again.

Good day. I have a situation that maybe someone has dealt with. I have a 2018 B2650. I ordered a set of hydraulic filters that were advertised for this specific tractor. When I went to install them, they didn't fit. The threaded female connection on the filters themselves were too small...

If it's a normal operation, no need to fix it. Guess I never noticed it until recently. Maybe I need to pay attention more...thanks...

Bucket weight has little difference with the RPMs lowering. As far stroke position, RPMs reduce about 2/3 of maximum.

Thanks... normal is good.

Have an issue I can't figure out. And the answer is probably simple or so I hope. 2018 B2650. I raise the bucket high and the engine's RPMs lowers. I drop the bucket and the RPMs return to normal. Any ideas?

I'll do that...thanks. Hopefully it will be something that simple.

Thanks I.W....stupid is as stupid does...when I jumped the solinoid this time, my butt was in the seat, and it started. Getting old is scary sometimes...but thanks again.

Thank you...thinking I'll recheck all fuses again...

Thanks...

No blown fuses, fuel solenoid ok and did remove to check and clean the starter. It all looks good but bendex doesn't engage so thinking to just replace the solenoid.

Good morning. I own a 2018 kubota 2650 hsd. Was wondering if I had 2 problems instead of just 1. While sitting on the tractor and turning the key, nothing happens. Battery is fully charged, pto in right position, ect... and when I jump across the solenoid, it just spins and doesn't...