Recent content by ronztractor

So I pulled off the front timing cover and your right it would take forever to recheck the settings. So I decided to start from the beginning and reset the marks. So with the piston at TDC with the 1TC marker centered in the window the piston is on compression or exhaust which is determined by...

Thanks for the replies, yes I know the compression is to low, I have the valves adjusted to 006 according to specs. I guess I’m wondering if I can bring #1 to TDC and the #1tc indicator on the flywheel is centered in the window can the valve timing still be off. Maybe I should do a leak down test

I will try and make this long story as short and accurate as possible. A friend asked me to complete a engine rebuild that someone else started but couldn’t complete. They had completed the lower half. Pistons, rings, bearings, with the timing gears installed and timing cover on. I installed...

Thanks for all your suggestions I’ll report back when I figure it out

I have a b7200 the battery is not being charged (12.5 volts) how do I test the generator it has two wires coming out of it.

Thanks for the info, I was afraid of that.

yes I have that picture but what I need to know is in order to replace the bracket the pto shaft that goes through it must be removed, how does the pto shaft come out, will it come right out the top ? it doesn't seem likely with the speed change lever on the bottom. or does it come out another...

need some help with my l2650, trying to remove the pto shift lever. does anyone know how it comes out of the transmission.

Ok thanks, just seems so wasteful. Also I hope they don't drop the ball on any respect or I'm screwed.

Need some help with my rtv my head has a crack in it. I taked to the dealership to order a new one and they sold me on a new engine. But they said before they could place the order I had to e-mail them a picture of the engine with a 2 inch hole I had to drill into the block to verify it was...

P/s issue figured out. I took both lines off controll valve like you suggested I have fluid out of only one hose at a time while turning in ether direction. But one thing I noticed was with one hose connected to cyl and one hose off while turning in one direction fluid would come out of other...

with the rtv off and the wheels off the ground the wheels will not turn when you turn the steering wheel.

thanks, i have about 1300 psi at the pump thats with the steering wheel all the way to rt or left. i also have that at the steer cyl on both hose in one dirrection or the other. i had heard the steering on the rtv has the type that allows you to steer when you loose assist. is there a way to...

Thanks for the reply,it's a rtv900g6-h65107. Thanks for the help I'll ck it out if it comes out both hoses. Also what psi should that pump put out?