Recent content by Rob18530

I own a 2014 BX2370 - Great little tractor, finding it a little under powered for bucket use and brush clearing. I looked around B2301 yesterday and was hoping I could get some feedback from folks who own the B01 model. Power, Lifting, Hauling.

Fluids are all good, fan blade is good, belts are all tight. My head is going to the water pump now. Does the engine have to come out to replace the water pump?

Did that with the flush

My BX2370 is overheating. I've completed a rad flush, changed out the thermostat, new 50/50 mix. Im at a loss here. Any suggestions l?

installed these feild ready stabilizers tonight Photo 1: Shows the product Photo 2: I inverted the steel bracket that hold the stabilizer to the tactor. It nows sits vertical rather than dropping down a bit. By inverting it I gained a a couple of centimeters in addition space for any rear PTO...

$189.00 US

Just ordered these a few days ago. They look like they'll make life much simpler when doing hook-ups with the 3 point.

I wanted to follow up on the Robalon replacement snowblower skid shoes. I've cleared a good amount of snow over the past few weeks. These shoes are awesome. I added an additional cutting blade to the bottom of my blower to get closer to the driveway. I have about am 1/8 inch of snow left on...

I own a 2014 BX 2370 and I'm looking for a good quality hitch for attachments. I've been impressed with Land Pride Hitches, my question. Can anyone let me know what Land Pride hitch will fit my Kubota. I'm new to the wold of tractors and could sure use some guidance. Thanking you all in...

I'll be ordering some of these. Thanks for the tip

Got it free - three days of penetrating oil and impact driver and these "stripped bolt remover" sockets. It's out... now $37.00 for a new vent fill bolt... OUCH Now into repairing the plastic cracked front support bracket.... I'll post some photos of this peice of crap.

That's the same gear housing. I thought the vent was the fill. How would you recommend filling from the front plug?

Of course not.... lol

I'm using a six point socket.

The 11 mm bolt is seized. It's now starting to strip. Any suggestions on how to get this to release. I've sprayed with oil, heated the shit out of it, it won't release