Recent content by rjonen

count your lucky stars, Don't break something that isn't broke. My 3p will not lift anything and I have not had time to fix it.

ditto on replacing the clutch, few notes make sure you get the clutch disk in the right way, it is marked on the disk. You will need a alignment tool. May ask the dealer if he has a old main shaft. If you have a loader on that is half the work. Good luck

Well that worked fine, got it all back together, used hacksaw blades to hold the spring loaded stops in. It was outside but I had it covered with 2 tarps. But now the oil is foaming some. I did add a quart of oil. Does anyone have a idea what would make the oil foam, I don't think it was before...

Working on a L245DT, putting the shifting levers back in. Manual says to Shift the main speed gear to F4 (F8) I can't find F4 or (F8) anywhere in the manual. This is I take it to get the main gears in correct place to put the shifting forks in. My manual has this on page 163. I think...

I'M rebuilding a L245DT transmission. So I ordered some new parts, one is a PN 35110-21750 a 1 and 1/2 inch long sleeve that goes over the bottom PTO shaft. The old one had too large of a diameter and so does the new one. Currently have a call into kubota. Inside diameter of sleeve is approx...