Recent content by Ripp

What I don’t understand is why it’s hooked up this way (in on the side) when there’s clearly an in right next to where the out is.

The return comes out the fel control and go’s to a fitting almost under the seat of the tractor.

The fel works fine. Both the in and PB go to a box, with a lever on it, attached to the side of the block. I turn that lever to the left and the fel doesn’t operate R side the in. L side is hooked to the PB. From there the pb line becomes metal and goes all the way back to the 3ph.

Can someone help me out? Not sure my FEL control is hooked up right. Part # is 27fabs6m1ab and the “in” line is hooked opposite the PB port. Not in the IN port. Backstory; my 3pth moves when operate the FEL. Can’t seem to figure out why.

Thanks. What is that that’s highlighted there? The 3ph moves a good 6 inches up/down (estimated) while I work the fel.

Hello all. New member. Recently picked up a B6200hst. I’ve noticed a couple issues that I can’t figure out; 1) the hitch bounces up and down when I move it to a certain position. 2) When operating the FEL the three point hitch moves up or down with the bucket. I know this isn’t right. All lines...