Recent content by Remote 95

Update 4/24, We have removed and blocked off the EGR/ heat exchanger ports, But have found that not to be the problem? Today after changng the filter and adding new oil to the motor it was cranked and running smoothly. In the Ten minits it was run we kept pulling the dipstick and saw the...

Takeuchi with V3307 Kubota. I have a TL230 with a V3307-DI-T-E3B-TLTUI, Serial #223100002-OE-TL230-A Should I just remove the EGR/Cooler, Block off, so I can Definatrly see if coolant is again mixing with Oil?

I want to pressurize the system without the EGR cooler to test for head gasket or below problems. Since there is a possibiltiy of the EGR/Cooler mixing coolant with the oil. If i isolate and the oil turns chocolate then the problem is definately going to be head or below? If it is the head or...

I need to isolate the EGR/cooler to be able to pressureize the radiater. Iconnected the two 7/8 hoses coming from downside of the engine block. When Radiater was pressurized water exited where one of the two hoses had been. Specificallly the hose fitting on end of cooler at bottom, away fron...

1st, Want to Know If I can reroute the hoses on the EGR/intercooler/? I was told today to take the two hoses and join them together thus bypassing the EGR/intercooler? I looked at it today and I think it can be done but want advice for learned people like yourselves? 2nd. From learned person was...

Much Thanks on this thread, I will take the questions as advice, and will use the advice given, However I am going to start a new thread and would like to share some info found today?

Does the Kubota V3307-Di-T-E3-B have sleeves in the engine to be replaced? Is Cavitation a problem in this engine? Where can I get a repair manuel?

Bought at auction Takuchi with Kubota V3307-DI-T-E3B-TLTU1, Oil was chocolate but the machine cranked and ran fine, although I didnt run it but a minite. Other than cracked head or maybe block damage is there anywhere else to look to on this machine for the problem.? All help appreciated!

Guess Again but this time try using the intelligence of an adult not a 13 year old. Since i was born in 1957 and Dad died 21 years ago that disqualifies me as a milleneal thankfully. My machine was bought at Auction ( a place notorious for not adhering to manufacturer parts) and in addition...

Hi to all, Have just bought used Zero turn and was going to change the blades. Have purchased blades, bolts, washers for blade change. Can anyone provide the pictures and the diagram of how the blade, washers, bolts, etc are stacked on this machine. I have looked and ahve been unable to find...

Need Blade spindle K221-72291. Cant find this part. Anybody know where to get or what will work even if not Kubota?

Will the deck spindle for a kubota RC-F20 interchange with a kubota RCK54TG ? If the whole spindle unit does not interchange will the shaft itself be the same for both decks?

I didnt mean to post 3 times. Not great with computer and too many ads in the middle of the page, very confusing!