Recent content by Redstickla

Thanks for the info Kenny. I'll let you know how it goes once we get the other valve on or if there are any other issues.

Looking from the side, the upper left connection is the supply line to the motor tee'd into the PB. The connection on the right is the return line from the motor tee'd into the OUT of the FEL. Currently this setup is not working because the flow of the PB is being divided between the motor and...

I'm hoping the pic is attached. Looking down from above, the hose coming up toward the camera is the feed line to the motor. The yellow handle is the shut off valve on that line above where it is tee'd into the PB line. Just below and right of the yellow handle is the return line from the...

Also, the cutter flow requirement is 3.3 GPM.

Kenny, I hope to have some pics up later today. All components are high pressure. The tractor puts out 7+GPM @2200+psi. All lines and ports are 1/2" and the valves are rated at 4000psi, if I remember correctly. My concern is if I cut flow of the PB to the 3PH and redirect it to the cutter...

Kenny, thanks for responding and the schematic, forgot to say that earlier. So one error I made was thinking the fluid flow was from block to FEL through the PB line. The fluid flows through the FEL from the IN line to the block and "helps" the 3 pt. the line I have running to the motor...

There are 7. 4 lines out to the bucket operation, 1 line out running to the back of the tractor under the seat ( this line i was going to tie into coming ot of the cutter motor), 2 lines connected to the hydraulic block and into the FEL one in and the other power beyond. The power beyond is...

Guys, I'm new to the site and probably know just enough about tractors to get myself in trouble. I have a L2500 with a LB400 loader. I am trying to install a Sabre Samuri cutter. It's run by hydraulic running through a motor driving a verticle cutter. It's a continuously running motor with...