Recent content by Rainman13

I took it all apart and the bottom of the front gear case is definitely out of round. I had a heck of a time getting the bottom bearing to drop out. I found a used one and measured it with calipers. It measures 2.80 +/- .04 all the way around. The old one varies from 2.814 to 2.781. I can see a...

The bearings are definitely getting changed. I ordered those today. Both of the seals were one-piece seals. I may not be able to get into it right away, but I'll definitely post pictures when I do. I appreciate all of your help.

Thanks, I appreciate the feedback. I know it sounds a bit extreme to replace cases to fix a leak, but this is the third time I've replaced them on this side in 600 hours. I'm pulling my hair out. With this leak happening this soon after the last change, I'm starting to wonder if some of the...

I know there are tons of posts here about the leaking front oil seals on a lot of Kubota tractors. The last time I replaced the seal on the right front hub was only in March, and it's leaking again already (less than 10 hours of run time :mad:). Reading more about this, many are saying if the...

If you still have a grill for the L4200 let me know. Thanks

Do you have a grill for an L 4200?

I have tons of parts off of an L4200 project, including g a bell housing. Check to see if it will fit, I'd love to get some of this stuff out of my garage

This is the one I just made from a 55 gallon drum for my L4200 (hope the image attached). It ended up weighing about 1200 lbs but I am using it to run a grapple bucket picking up logs. I made an attachment point for the top link because I didn't like the idea of this thing rocking back and...

Edited, prices dropped

Parts are from a Kubota V2203 engine that had 1400 hours on it. I listed the big parts, if you don't see it on the list email or PM me and I will look to see if I have it. I basically have the whole engine except the block and crankshaft. Willing to deal to get this stuff out of my garage...