Recent content by powerkraut

Thank you all!

Servicing the tractor today and notice this little valve on the air filter housing is ripped. What is this called so I can order a new one? Also, if anyone can point me to a writeup on changing the hydraulic oil and the front axel oil on a bx2230 i'd appreciate it.

Cleaned the hole out, closest dealership is over 2hrs away. I could get it online if I knew the part #. I know there's a website that has parts lookup, but I can't remember it or find it again.

Cool, I heard a hiss when I removed it, but there could have been negative pressure in the gear box.

Hey all. Spring is finally here so I'm servicing my mower deck and putting it back on the tractor. My vent plug looks buggered and I'm not sure if I need to replace it. Can anyone tell me if this will still vent, and if not where I can get another one?

Tons of advice here, thank you all! I think I've got a good starting point in the arccaptain, plus an idea of what to keep an eye out for used. I do make the 6 hr drive to a major metro area a few times a year so upgrading with a used machine isn't impossible. I was planning on spending good...

I appreciate all the input and I know this kind of stuff can be a "buy once, cry once" kinda deal but I'm not prepared to drop $1300+ on just the welder when I'm trying to learn and see if it will even be worth my time. I'll definitely keep an eye out for used millers or hobarts, but I'm likely...

No aluminum, welds would be on carbon and mild steel from 24ga - 1/4" plate for all the stuff I've been putting off. Sounding like a decent 220 mig would give me the best chance at actually succeeding at faking my way through them. I'd still like to end up around $400 though if that's even...

I live in northen new england far from civilization so the usual advice doesn't really hold true, hence why I'm looking for something I can mail order that would be easiest to learn on. I can add a 220v outlet if I need to go that route.

Ideally 110v, no multiprocess, and budget is about harbor freight level until I figure out if I can even develop the skills to get my money's worth out of it. I've been seriously considering getting one of the chinese tig machines off of temu since users on a hobbyist forum I frequent have...

I'm just stacking up too many repairs that require welding, the time has come to buy a welder and figure it out. I have some very minor experience using mig, but that was always under supervision and years ago. Can anyone reccomend me a beginner rig that I can fake my way through and is...

That was the first thing I checked, the picture may not show it, but in the full rearward position there's still about 1/2" of clearance where it's not touching anything, I'm also pushing on the linkage that the level is connected to so lever flex is not part of the equation.

That pin is in there solid woth no play

There is nothing WD-40 is used for that something else doesn't do better. I undercoat the vehicles with woolwax every year and I hit the tractor and implements while I'm at it. I live in the merrimack valley where I'm constantly dealing with slush and I don't get clogs unless I get behind and...

I have a bx2230 and it feels like there is something wrong with the pto selector. When I keep it pinned to the rear only the front pto is active, but vibrations move it slightly forward and the rear pto engages as well. Playing with the stick it feels like there are 2 stong engagement points...