Pawnee's latest activity
-
This is why I have security cameras. The one at the end of of driveway has four small infrared lights that flash when taking a night... -
Pawnee reacted to Runs With Scissors's post in the thread I’m just “Skating through life”…………….. with
Like.
Now it's “go time”……Gotta give these bad M’frs a try….. So I have to get the BP “up a little” so that I can put the skates under it... -
Pawnee replied to the thread L4060 Main fuse?.Put an 80A in. If it doesn't blow you're good to go.
-
Pawnee replied to the thread Explain this feature and function please.......?.I have only used it a couple of times. If you want to get on/off the tractor from the right side for some reason then it's a good...
-
Pawnee replied to the thread Name that Tool.I don't know what those blocks are but I'm pretty sure they are not machining related. Sometimes you come across material too good to...
-
For sure you don’t want to just have the nuts snug! They should make you hurt quite a bit to get them to the correct torque. I think...
-
Pawnee replied to the thread Zero turn Z242 mower belt way too tight.No. The mower was new this Spring so I'm assuming it is right.
-
Pawnee replied to the thread Zero turn Z242 mower belt way too tight.No through bolt but I like that idea. I wanted to be sure I could put it back to stock if necessary. Also makes it easier to change the...
-
Pawnee reacted to Runs With Scissors's post in the thread Zero turn Z242 mower belt way too tight with Like.
Thank you for the kind sentiment, and nice job on the write up and your solution. Does that "secondary boss” get a nut on the backside...
-
Pawnee replied to the thread Zero turn Z242 mower belt way too tight.Thanks Wolfman but the belt is completely off in the pic, I don't think it's possible to route it incorrectly. The diagram is very clear...
-
Pawnee replied to the thread Zero turn Z242 mower belt way too tight.It put too much radial force on the pulleys, specially the clutch output pulley which sticks out quite a bit under the engine. The belt...
-
I finally got around to addressing this problem. It won't be as exciting as "Runswithscissors" but here goes. The mower belt has a...
-
-
Or let my grandson play on it for about 20 minutes. No one will be able to start it then.:)
-
Pawnee replied to the thread Turned it one time too many..I can't see if that's the negative or positive but if it's the positive then vice grips are going to be a bit risky. I would cross drill...
