Recent content by Ole69

  1. O

    Kubota d722 running horribly after oil change

    I wasn't sure if it was over heating and causing an issue. Funnily enough, the thermostat was stuck closed. Removed it, and did ok for a bit. Back to sputtering. Im wondering if I have a sticky injector at this point. I have good pressure from tank through the pump and right up to the injectors.
  2. O

    Kubota d722 running horribly after oil change

    I did however just pull the radiator cap. It's full but... Even warmed up, nothing moving. It will idle perfectly fine. Bring the throttle up and starts having issues again. Think I'm going to pull the thermostat and see if its stuck closed. 🤔
  3. O

    Kubota d722 running horribly after oil change

    I think I stirred something up when I jacked it up. Funny though that I go up hills with more of a pitch that what I had it jacked up at. Before I replaced the filters I emptied the tank with a hand pump connected to the filter just before the injection pump. It seemed like there was resistance...
  4. O

    Kubota d722 running horribly after oil change

    Good morning. Went out and changed my oil on my tg1860 with the d722e. I use Rotella 15w40 with the Wix filter (part #51365). I usually change it with the deck off, this time I just jacked up the front to fit my oil catch pail. After the change, I started it up and it ran great for about 5...
  5. O

    TG1860D HST fluid change

    Quick question. I having the same issue. I just removed my rear tires. I have the oil level check for the gear box, but can't find the drain anywhere on the hst. Where was it located?