Recent content by NRoweyL47

Are Magnets part of the new filter or is this somthing that needs to be removed and cleaned?

So If I stick my wife at the fill port with my Dewalt shop vac while I pull the three filters I should be good to go? Wow cool trick...

Doing the Hydraulic / Transmisson and Hydrostatic Filter change on 2024 L47 TLB. The maint book says to change these filters at first 50 HR Service . Looks like they all use the same fluid with a single fill UDT fill port behind the Seat. My question is one filter is on the Left Lower Center...

Two restrictors on the way from BoltOnHooks Quick question: If I find control to be not quite what I am looking for, is it possable to redrill the restrictors to the next drill size up? Thanks for your help everyone.

It looks like the fixed .031 1/2 restrictor from BoltonHooks would fit well. But how do I know the fixed .031 would be a good flow rate for my aplication and would I need 1 or two.

I just added a 60" Grapple to my 2024 L47, The problem I have is that it reacts to quickly. Is there anyway to slow the response time down. Is the 3rd function valve adjustable, this thing is slamming open and shut. Thanks for any guidance.

Ya, I gues running at a higher RPM will be somting I will have to get used to. Thanks

thanks for all the guidence....

I have 10 hrs or so on a 2024 L47, I have been taking it easy running aroud 1500 to 1800 RPM for light duty tasks. Running for about 1 hr at a time just doing od jobs around property. I have noticed the particulate matter percent guage is already at 30 pct. Also I am letting it warm up at Idle...

sorry i did not see your second reply , so ther is no way to get down pressure?

Thanks for that pic explanes a lot , will that give me down pressure to my 3point or only angle, if it is for down pressure wont it just puse the exsisting lift arms to the top of there reach

From my previous B3200 I have a 60" York Rake 60" tiller and a 72" aerator I have always woundered ho to get downpressure on the rake but is sounds like i would need more components like cylinders etc.

I have a new L47 that came with a Rear Remote Function Control Valve that has 3 levers and 6 ports. Valve was added to tractor by dealer before purchase. I am woundering what can I run with this. Thanks for any guidence of what might be my options.