Recent content by nave.lb

Maybe i'm too late here....have you considered high content silver braze? It may not be a feasible Option depending on the crack and how far you want to go. But it is a really good repair for cast iron. Just food for thought.

Is there any reason I can't drive it up to the shop as long as it stays out of 4X4? I don't foresee it causing a problem but idk for sure.

Those are great. What i was going off of are not nearly as clear or detailed. Thank you.

Ya i wasn't thinking. And these zerks sure took grease. I guess I am used to pumping grease in a zerk and purging out the old and was thinking thats what i would do here. but those knuckles and king pins are a little different in that respect .

Thank you. I appreciate it. The front axle is the only thing I have not been through on this one. So i guess its not all bad. Im wondering if i can put the front axle from one of my hydrostats under it while i wait for parts and go through everything? I have an extra in the shop.... I would...

Thats what I thought. A good amount. I was pumping grease into the zerk on the steering arm knuckle and it was pushing some nasty old grease out from the dust seal. So i figured i would flush it out. Apparently out from the deal seal wasn't the only place it was being pushed. The front axle is...

I have an early B7100-D with ball and socket type steer knuckles. The front axle is the only thing i havent been through and I decided to grease it after i got done using the tractor last night. It started purging old grease out of the knuckle so i decided to keep going until it came out clean...

I appreciate the responses on this post. Im new to hydraulics and not good at this computer thing. Im definitely still learning!

Thank Thank you. I do appreciate the response and the information you provided. Im new to hydraulics. I will get a gauge and check the pressure.

O Ok. I will do that. Thank you.

Correct. It is not rocket science. Its simple. I was simply stating what i have done. . I do not know the exact weight of what I was lifting but I do know that it was under 500 pounds. Probably around 400. I didn't have a scale handy. I came here to ask for help. You'll have to forgive my...

Im here asking a question so i can get informed answers. Not guessing. I do not have any quick connects on them.

Im here asking questions for a reason. Thanks.

Im not at capacity. The tilt cylinders will lift the same load with no issue.

I have b7100 with a b219 loader operated with an independent pump. I just recently rebuilt the cylinders. Everything seems to function fine but when i try to pick up a heavy load the lift arms have no pressure to go up. The tilt cylinders will lift the same load just fine but the arms wont. It...