N3BP's latest activity

  • N3BP
    N3BP replied to the thread Help me Shift L3710 out of 4WD.
    Try placing your right foot on the treadle pedal and rock it back and forth (moving the machine slightly forward, then slightly...
    • L3710-Front.jpg
    • L3710-Rear.jpg
  • N3BP
    N3BP replied to the thread B7200 running hot.
    Glad to hear you got it installed and it's working. I had to cut the grass today, so I thought I'd share my readings. It was 75 (24c)...
  • N3BP
    N3BP replied to the thread B7200 running hot.
    I'm curious to hear what your temp readings are, so please report those back. I installed the temp sensor in a port plug on top of the...
    • IMG_2586.JPG
    • IMG_2587.JPG
  • N3BP
    N3BP replied to the thread B7200 running hot.
    I don't think an overflow is needed. Adding that temp gauge will go a long way to help prevent major overheating. You'll learn its...
  • N3BP
    The grand L10 series use lug-centric front wheel with tapered holes. The exception is a model with a 5-15 front rim. that is a...
  • N3BP
    Looks like your lugnuts are on backwards too. Bevel end faces the rim.....
  • N3BP
    N3BP replied to the thread B7200 running hot.
    Before you toss your old radiator, you might consider taking it to a radiator shop to see what they can do for you. Mine got a pinhole...
  • N3BP
    One of those relays behind the dash is for the key stop system. I'd turn the key off and start wiggling them to see if one makes...
  • N3BP
    N3BP replied to the thread B7200 running hot.
    You might also consider installing a temperature gauge. It's a good indicator when your radiator screen starts to clog. My 7200HST...
  • N3BP
    Diagnosing wiring issues is always fun (not). You need a wiring diagram and a fair amount of patience. Work your way from source to...
  • N3BP
    I'd check for a mouse nest and chewed wiring where the harness runs through near the bellhousing. Remove the large rubber plug and seen...
  • N3BP
    N3BP replied to the thread L3010 float mode ?.
    See attached images from the manual for an explanation of the "float" control.
    • IMG_2558.JPG
    • IMG_2559.JPG
  • N3BP
    N3BP replied to the thread B2401DT and a Woods RM59 mower.
    When I first got my gear-drive B7200 (which has less PTO HP), It had an RM59 attached to it. You'll have no problems other than gettin'...
  • N3BP
    N3BP replied to the thread Mower deck attachment and removal.
    Given these decks haven't been produced in over 30 years, there is little to no aftermarket support for them. The mid-pto is an oddball...
    • IMG_2466.JPG
    • IMG_2467.JPG
  • N3BP
    Attached is a page from the service manual. You might have to dissemble the entire thing to get that out.
    • IMG_2427.JPG