Recent content by Mtncrzy

Thanks looks like a start. I will have to contact them to see if they have the full measurements for the B2650, I'm guessing so. I have almost zero knowledge of hydraulics. So they can probably guild me in all parts I will need. It will be installation that I maybe lost on.

I've come to learn that Kubota does not make a 3 point tip/ tilt system for the B2650. I've talked to 2 different dealers and both saying they have done it before, but they will have to do some research and get back to me. Neither has gotten back to me. Any recommendations ?

Yes . Realized my mix up in description today as I was double checking my fluid levels. ( Engine oil filter. ) So it doesn't cause extra wear on the hose ? Still makes it a little difficult lining up the filter being cautious of threads. I just don't work physically well off the floor anymore...

All Good replies. Thanks for the help. Time to move forward. Did anyone else have the Radiator Hose tight against the Tranny Filter from the factory ?

On a B2650. Replaced Tranny Filter (all good). The manual says then to also replace Hydraulic Filter but not the fluid. Can you replace the Hydraulic filter without draining down the fluid first, which the manual says to do. Procedure says to drain, but the 50hr chart says just filter. I'm...

Yes PA452, That was my exact first thought. Off the engine is what I would think.

Thanks nbryan, I was figuring it would come to something like that.

New to Kubota but not equipment. But this dummy left the key in the on position some how. My hour meter went from 11 hrs to 36 hrs without running. Which is going to make it hard to follow my maintenance schedule. I doubt, but is there a was to correct this ?